Aluminum TNT door handle lever. Laser cut from 1/8" thick 6061 aluminum. Style and function at a price that can't be beat. Sold individually. Click "Add to Cart" below and select your quantity on the Checkout page.

Digi-Set delay timer. These Digi-Set delay timers are used to delay your second stage of nitrous. Fully adjustable from 0.1 to 102.3 seconds of delay time. This is what the Pros use. Instructions and easy to read wiring diagram included.

1/4" thick crank pulley spacer for small and big block Chevy. Perfect for getting your lower crankshaft pulley back into proper aligment after installing a front motor plate, or to just correct other pulley alignment issues. We have 1/4" thick spacers as a direct fit for both small and big block Chevy with the correct receiver rings machined right into the spacer. Sold individually. Please choose which spacer you need in the drop down box below.

#170040: 1/2" thick TNT Pro wheel spacers. Fits 5 x 4 3/4" and 5 x 5" bolt circles. Will fit 5/8" wheel studs. Sold individually. Click "Add to Cart" below and select your quantity on the Checkout page.

Strange aluminum dual inline bore master cylinder. Your choice of 1.032" or 1.125" bore. Please use the drop-down box below to make your selection.

1.032" bore is optimum for vehicles with 1 or 2 piston front calipers and rear 4 piston calipers or drum brakes.

1.125" bore is optimum for vehicles with 4 piston calipers front and rear.

Rear end lower control arm housing brackets. Our new TNT housing brackets are designed to give you infinate adjustability in your rear suspension. They give you 11 different positions in 1/2" increments. These are a must for anyone who wants their car to work to its full potential, especially lowered cars. Laser cut from 1/4" thick steel with 1/2" holes. Fits 3" axle tubes, but can be modified to fit larger axle tubes. Sold in sets of four.

Double throw battery kill switch lever. Machined from 6061 aluminum, this lever is designed to bolt directly to most aftermarket battery kill switches when using a push/pull rod to actuate the switch. The double throw design offers you the ability to attach the push/pull rod and also a cable to run inside the car to a lever to actuate the kill switch from inside the car as well. Each end is machined to accept a 10-32 rod end for attachment. Sold individually.

Tube flange kits. These laser cut, 1/4" thick steel, these flanges are designed to make your tubular transmission crossmember or other basic chassis cross tubes removable. We have them available to fit 1 1/4", 1 1/2" and 1 5/8" round tube and feature 4 bolts per flange. Sold in sets of four flanges with hardware included. Use the drop-down box below to select your size.